LevelOne WBR-6005 - Manual (Page 37)

◆ MAC Clone — Some ISPs limit Internet connections to a specified MAC
address. This setting allows you to manually change the MAC address
of the Wireless Router's WAN interface to match the PC's MAC address
provided to your ISP for registration. You can enter the registered MAC
address manually by typing it in the boxes provided. Otherwise,
connect only the PC with the registered MAC address to the Wireless
Router, then click the ―Clone your PC‘s MAC Address‖ (Default: Disable)
S TEP 3 - WAN
S ETTINGS - PPP O E
Enable the Wireless Router IP address to be assigned automatically from
an Internet service provider (ISP) through a DSL modem using Point-to-
Point Protocol over Ethernet (PPPoE).
Figure 17: Wizard Step 3 - WAN Settings - PPPoE
The following items are displayed on this page:
◆ User Name — Sets the PPPoE user name for the WAN port.
(Default: pppoe_user; Range: 1~32 characters)
◆ Password — Sets a PPPoE password for the WAN port.
(Default: pppoe_password; Range: 1~32 characters)
◆ Verify Password — Prompts you to re-enter your chosen password.
◆ Operation Mode — Enables and configures the keep alive time and
configures the on-demand idle time.
◆ MAC Clone — Some ISPs limit Internet connections to a specified MAC
address of one PC. This setting allows you to manually change the MAC
address of the Wireless Router's WAN interface to match the PC's MAC
address provided to your ISP for registration. You can enter the
registered MAC address manually by typing it in the boxes provided.
Otherwise, connect only the PC with the registered MAC address to the
– 37 –
C HAPTER 4 | Initial Configuration
Setup Wizard