beautypg.com

Safety belt extension assembly, Seating and safety restraints – Lincoln 2009 Navigator User Manual

Page 603

background image

To adjust the comfort guide:

1. Slip the shoulder belt into the
belt guide. (The portion of the belt
between the latch tongue and the
D-ring, not the portion where the
belt exits from the quarter trim
panel.)

2. Slide the guide up or down along
the webbing so that the belt is
centered on the occupant’s shoulder.

WARNING: Position the safety belt comfort guide so that the
belt rests across the middle of your shoulder. Failure to adjust

the safety belt properly could reduce the effectiveness of the safety
belt and increase the risk of injury in a collision.

Safety belt extension assembly

If the safety belt is too short when fully extended, there is an 8 inch
(20 cm) safety belt extension assembly that can be added (part number
611C22). This assembly can be obtained from an authorized dealer.

Use only extensions manufactured by the same supplier as the safety
belt. Manufacturer identification is located at the end of the webbing on
the label. Also, use the safety belt extension only if the safety belt is too
short for you when fully extended.

WARNING: Do not use extensions to change the fit of the
shoulder belt across the torso.

2009 Navigator (nav)
Owners Guide, 2nd Printing
USA
(fus)

Seating and Safety Restraints

179