Liebert UPS - Manual (Page 18)

UPS Web management by Liebert IS-WEBRT3 Card
14
Figure 17 Network
5.3.4 SNMP
This page is to set Liebert IS-WEBRT3 card SNMP settings so it can be used by an NMS ( Network
Management System).
MIB System
System Name—This section is used to give a name to a Liebert IS-WEBRT3 card.
System Contact—This section is used to list a name for the administrator.
System Location—This section is used to set the Liebert IS-WEBRT3 card’s location.
Access Control
Manager IP Address—This section is used to set the IP address so that the administrator can man-
age the Liebert IS-WEBRT3 card. It is valid for up to eight IP addresses. To manage the Liebert
IS-WEBRT3 card from any IP address, enter *.*.*.* into the IP address.
Community—This section is used to set a Community name for NMS. The community name must be
the same as the setting in NMS.
Permission—This section is used to set options for administrators. Options are Read, Read/Write,
and No Access.
Description—This section is available for an administrator to make notes.
Trap Notification
Receiver IP Address—This section is used to set the receivers’ IP address for traps sent by the Lie-
bert IS-WEBRT3 card. It is valid for up to eight IP addresses.
Community—This section is used to set a Community name for an NMS. The community name
must be as the same as the setting in the NMS.
Severity—This section is to set Trap receiver levels. There are three levels of Trap receiver:
• Information: To receive all traps.
• Warning: To receive only “warning” and “severe” traps.
•
Severe: To receive only “severe” traps.
• ( Please refer to NMS manual for Trap levels.)
Accept—This section is to set whether the Destination IP Address will Accept traps.
Description—This section is available for an administrator to make notes.
Event—This section is used to select the events that will be sent to the associated IP address. Click-
ing on Select will open a Select Events List. Event Traps may be selected from this list.