Liebert 30-130kVA User Manual
Npower
Table of contents
Document Outline
- Important Safety Instructions
- Save These Instructions.
- Overview Of Manual
- 1.0 Introduction
- 2.0 Theory of Operation
- 3.0 Operation
- 3.1 Operator Controls
- 3.2 Security Access and Passwords
- 3.3 Display Screens and Procedures
- Figure 8 Menu tree
- Primary Screens
- Secondary Screens
- Main Menu Screen
- 3.3.1 Mimic Display Screen
- Figure 10 Monitor / mimic display screen example: normal power flow
- Figure 11 Mimic display screen example: utility fail
- Figure 12 Mimic display screen example: load on bypass, UPS module on and charging battery
- Figure 13 Monitor / mimic display screen example: load on bypass, UPS module off, service mode
- Figure 14 Mimic display screen detail
- Detailed Information Reports
- Faults and Alarms
- 3.3.2 Startup
- 3.3.3 Shutdown
- 3.3.4 Status Reports
- Figure 33 Status report screen
- Figure 34 Event log report screen showing most recent event
- Figure 35 Event log report screen showing previous event
- Figure 36 Event log report screen showing previous event
- Figure 37 History log metering report screen
- Figure 38 History log status report screen
- Figure 39 History log faults/alarms report screen
- 3.3.5 Configuration Screens
- Figure 40 Configuration screen
- System Ratings
- System Settings
- Figure 43 System settings screen, page 1
- Figure 44 Date setting screen
- Figure 45 Time setting screen
- Figure 46 System settings, page 2
- Figure 47 System settings, page 3
- Figure 48 Enter password screen
- Figure 49 Single /dual input screen
- Figure 50 Options screen, page 1
- Figure 51 10% passive filter settings screen
- Figure 52 Options screen, page 2
- Figure 53 Options screen, page 3
- Figure 54 Options screen, page 4
- Figure 55 Communication options Screen, page 1
- Figure 56 Auto dial screen
- Figure 57 Modem selection screen
- Figure 58 Auto dial screen, page 2
- Figure 59 Pager support configuration
- Figure 60 Communications options screen, page 2
- User Settings
- Factory Settings
- Alarm Mask
- AUTO DIAL
- Customer Alarm Interface
- Figure 73 Customer alarm interface screen
- Figure 74 Customer alarm interface screen, page 2
- Figure 75 Programmable output relay board #1, AS400 assignment
- Figure 76 Relay assignments
- Figure 77 Programmable output relay board, standard set
- Figure 78 Programmable output relay board, standard set, page 2
- Figure 79 Programmable output relay board, user defined
- Figure 80 List of alarm faults screen
- Navigating Protocol
- 3.3.6 Manual Transfer
- 3.3.7 Battery Management
- 3.3.8 Auto Restart
- 3.3.9 System Status Monitoring
- 3.4 Faults, Alarms, Status
- 3.5 Communication Interfaces
- 3.6 Modes Of Operation
- 4.0 Maintenance