Liebert UPS System User Manual
Page 15

Chapter 1 Introduction
9
Parameters of Liebert iTrust UPS are given in Table1-1
Capacity 20kVA
30kVA
40kVA
60kVA
Model UL33-0200L
UL33-0300L
UL33-0400L
UL33-0600L
Input Voltage
380/400/415V(line-to-line voltage)
AC Power Input
Three-phase three-wire
Power Factor
>0.99
Harmonic Current
<4%(Voltage distortion lower than 2% at rated load)
Voltage Range
+15%~-20%
Lowest operating voltage: -45%
Input current limiting
Input Current: <115%In for continuous operation; 115~140%In
for 5 minutes; 140~165%In for 1minute; Current limiting at
current over 165%In(In is the rated output current without
deration)
Rectifier
input
frequency range
50Hz ±10%
Input Voltage
380/400/415V(line-to-line voltage)
Input Voltage Range
±
10%
AC Power Input
Three-phase four-wire
Bypass input
Frequency range
50Hz±10%
Voltage regulation
(balanced load)
380/400/415V±1%
(±5% adjustable)
Voltage transient response
±
5%(0~100%linear load)
Transient recovery time
<60ms
Voltage distortion(linear load)
THD<2%(line-to-neutral voltage)(battery float charge state,
rated balance load)
Voltage distortion(nonlinear
load)
THD<5%(line-to-neutral voltage)(battery float charge state,
rated balance load)
Power Factor
0.8(lagged)
Frequency Syn. Range
50Hz±2Hz
Frequency regulation(Battery
mode)
±
0.1%
Phase Displacement (Three-
Phase)
120± 1°(balanced load or unbalanced load)
Voltage unbalance rate at
100% unbalance load
±
2%(battery float charge state)
Output
Frequency slew rate
<1Hz/s