Lexmark C522 - Manual (Page 108)

Disabling Power Saver
108
Administrative support
Disabling Power Saver
Disabling Power Saver is a two-step process. First, the menu item is turned on, and then the menu item is selected.
1 Turn the printer off.
2 Press and hold and while turning the printer on.
3 Release the buttons when the clock appears.
CONFIG MENU appears on the first line of the display.
4 Press until Energy Conserve appears, and then press .
5 Press until Off appears, and then press .
Submitting Selection appears. The operator panel returns to the CONFIG MENU.
6 Press until Exit Config Menu appears, and then press .
Resetting the printer appears briefly. The operator panel returns to Ready.
7 Press to enter the menus.
8 Press until Settings appears, and then press .
9 Press until Setup Menu appears, and then press .
10 Press until Power Saver appears, and then press .
11 Press or until Disabled appears is on the display, and then press .
Submitting Selection appears. Power Saver is disabled.
Encrypting the disk
Warning: All resources on the hard disk will be deleted. Resources residing in flash memory or in RAM remain
unaffected.
Note: This setting is only available when a hard disk is installed.
1 Turn the printer off.
2 Press and hold and while turning the printer on.
3 Release the buttons when the clock appears.
CONFIG MENU appears on the first line of the display.
4 Press until Disk Encryption appears, and then press .
5 Press until Enable appears, and then press .
Contents will be lost. Continue? appears.
6 Press until Yes appears, and then press .
The Encrypting Disk progress bar appears.
7 Press when the disk encryption finishes.
8 Press until Exit Config Menu appears, and then press .
To disable disk encryption:
1 Turn the printer off.
2 Press and hold and while turning the printer on.
The clock appears followed by CONFIG MENU.