Lenovo J SERIES 3000 User Manual

Page 63

Diagnostic Error Code

FRU/Action

030-03X-XXX 030-04X-XXX SCSI interface error

1. SCSI signal cable

2. Check power supply

3. SCSI device

4. SCSI adapter card, if installed

5. System board

030-195-XXX SCSI interface Test aborted by user

Information only Re-start the test, if necessary

030-196-XXX SCSI interface test halt, error threshold
exceeded

1. Press F3 to review the log file

2. Re-start the test to reset the log file

030-197-XXX SCSI interface test warning

1. Make sure the component that is called out

is connected and/or enabled. See Chapter 6
“Diagnostics, Test and Recovery Information” on
page 41

2. Re-run test

3. Replace the component that is called out in warning

statement

4. Replace the component under test

030-198-XXX SCSI interface test aborted

1. If a component is called out, make sure it is

connected and/or enabled. See Chapter 6
“Diagnostics, Test and Recovery Information” on
page 41

2. Flash the system and re-test. See “Flash update

procedures” on page 185

3. Go to “Undetermined problems” on page 67

030-199-XXX SCSI interface test failed, cause unknown

1. Go to “Undetermined problems” on page 67

2. Flash the system and re-test. See “Flash update

procedures” on page 185

3. Replace component under function test

035-000-XXX RAID interface Test Passed

No action

035-0XX-XXX RAID interface Failure

1. RAID signal cable

2. RAID device

3. RAID adapter card, if installed

4. System board

035-195-XXX RAID interface Test aborted by user

Information only Re-start the test, if necessary

035-196-XXX RAID interface test halt, error threshold
exceeded