Lenovo J SERIES 3000 User Manual
Page 59
Diagnostic Error Code
FRU/Action
014-196-XXX Parallel port test halt, error threshold
exceeded
1. Press F3 to review the log file
2. Re-start the test to reset the log file
014-197-XXX Parallel port test warning
1. Make sure the component that is called out
is connected and/or enabled. See Chapter 6
“Diagnostics, Test and Recovery Information” on
page 41
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test
014-198-XXX Parallel port test aborted
1. If a component is called out, make sure it is
connected and/or enabled
2. Flash the system and re-test. See “Flash update
3. Go to “Undetermined problems” on page 67
014-199-XXX Parallel port test failed, cause unknown
1. Go to “Undetermined problems” on page 67
2. Flash the system and re-test. See “Flash update
3. Replace component under function test
014-2XX-XXX 014-3XX-XXX Parallel port failure
1. External parallel device
2. System board
015-000-XXX USB port Interface Test Passed
No action
015-001-XXX USB port Presence
1. Remove USB device(s) and re-test
2. System board
015-002-XXX USB port Timeout
1. Remove USB device(s) and re-test
2. System board
015-015-XXX USB port External Loopback failure
1. Remove USB device(s) and re-test
2. System board
015-027-XXX USB port Configuration/Setup error
1. Flash the system. See “Flash update procedures”
2. System board
015-032-XXX USB port Device Controller failure
System board
015-034-XXX USB port buffer allocation failure
1. Reboot the system
2. Flash the system and re-test. See “Flash update
3. Run memory test
4. System board
015-035-XXX USB port Reset condition detected
1. Remove USB device(s) and re-test
2. System board
015-036-XXX USB port Register error
System board
015-040-XXX USB port IRQ failure
1. Run setup and check for conflicts
2. Flash the system. See “Flash update procedures” on
3. System board
Chapter 7
.
Symptom-to-FRU Index
53