Lenovo J SERIES 3000 User Manual
Page 62
Diagnostic Error Code
FRU/Action
025-027-XXX IDE interface Configuration/Setup error
1. IDE signal cable
2. Flash the system. See “Flash update procedures” on
3. Reseat IDE signal cable
4. IDE device
5. System board
025-02X-XXX 025-03X-XXX 025-04X-XXX IDE Interface
failure
1. IDE signal cable
2. Check power supply
3. Reseat IDE signal cable
4. IDE device
5. System board
025-195-XXX IDE interface Test aborted by user
Information only Re-start the test, if necessary
025-196-XXX IDE interface test halt, error threshold
exceeded
1. Press F3 to review the log file
2. Re-start the test to reset the log file
025-197-XXX IDE interface test warning
1. Make sure the component that is called out
is connected and/or enabled. See Chapter 6
“Diagnostics, Test and Recovery Information” on
page 41
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test
025-198-XXX IDE interface test aborted
1. If a component is called out, make sure it is
connected and/or enabled. See Chapter 6
“Diagnostics, Test and Recovery Information” on
page 41
2. Flash the system and re-test. See “Flash update
3. Go to “Undetermined problems” on page 67
025-199-XXX IDE interface test failed, cause unknown
1. Go to “Undetermined problems” on page 67
2. Flash the system and re-test. See “Flash update
3. Replace component under function test
030-000-XXX SCSI interface Test Passed
No action
030-00X-XXX 030-01X-XXX SCSI interface failure
1. SCSI signal cable
2. Check power supply
3. SCSI device
4. SCSI adapter card, if installed
5. System board
030-027-XXX SCSI interface Configuration/Setup error
1. SCSI signal cable
2. Flash the system. See “Flash update procedures” on
3. SCSI device
4. SCSI adapter card, if installed
5. System board
56
Hardware Maintenance Manual Lenovo 3000 J Series