Lenovo J SERIES 3000 User Manual
Page 57
Diagnostic Error Code
FRU/Action
005-199-XXX Video test failed, cause unknown
1. Go to “Undetermined problems” on page 67
2. Flash the system and re-test. See “Flash update
3. Replace component under function test
005-2XX-XXX 005-3XX-XXX Video subsystem error
1. Video card, if installed
2. System board
006-000-XXX Diskette interface Test Passed
No action
006-0XX-XXX Diskette interface error
1. Diskette drive Cable
2. Diskette drive
3. System board
006-195-XXX Diskette interface Test aborted by user
Information only Re-start the test, if necessary
006-196-XXX Diskette interface test halt, error threshold
exceeded
1. Press F3 to review the log file
2. Re-start the test to reset the log file
006-197-XXX Diskette interface test warning
1. If a component is called out, make sure it is
connected and/or enabled
2. Re-run test
3. Replace the component that is called out in warning
statement
4. Replace the component under test
006-198-XXX Diskette interface test aborted
1. If a component is called out, make sure it is
connected and/or enabled
2. Flash the system and re-test. See “Flash update
3. Go to “Undetermined problems” on page 67
006-199-XXX Diskette interface test failed, cause
unknown
1. Go to “Undetermined problems” on page 67
2. Flash the system and re-test
3. Replace component under function test
006-25X-XXX Diskette interface Error
1. Diskette drive cable
2. Diskette drive
3. System board
011-000-XXX Serial port Interface Test Passed
No action
011-001-XXX Serial port Presence
1. Remove external serial device, if present
2. Run setup, enable port
3. System board
011-002-XXX 011-003-XXX Serial port Timeout/Parity
error
System board
011-013-XXX 011-014-XXX Serial port Control
Signal/Loopback test failure
System board
011-015-XXX Serial port External Loopback failure
1. Wrap plug
2. System board
Chapter 7
.
Symptom-to-FRU Index
51