Figure 3-21 configure satellite, Using the mcu interface – Lennox Hearth G8 User Manual
Page 78

Using the MCU Interface
54-0198
77
Return to "Manually Controlling
the Antenna
Configure satellite?
Yes
Next
Return
Configure satellite
A
B
Set Symb Rate: XXXXX M/S
-
Enter
+
Configure Symbol Rate?
Yes
Next
Cancel
Set Freq:
XXXXX MHz
-
Enter
+
Configure Frequency?
Yes
Next
Cancel
Configure A
Yes
No
Configure B
Yes
No
Set ID:
XXXXXX HEX
-
Enter
+
Configure FEC Code?
Yes
Next
Cancel
Set FEC Code:
X/X
-
Enter
+
Configure Network ID?
Yes
Next
Cancel
Use the -/+ keys to set each digit of the number. Selecting
ENTER will cycle the display through each digit and then
display the next configuration screen.
Note 2:
Use the -/+ keys to scroll through the available FEC codes:
1/2 - 2/3 - 3/4 - 5/6 - 6/7 - 7/8.
Use the ENTER key to accept your selection.
Note 3:
Note 2
Note 2
Note 3
Note 2
Polarization: XXX
-
Enter
+
Note 1
Use the -/+ keys to scroll through the available polarizations:
LHC - RHC - HH - HL - VH - VL.
Use the ENTER key to accept your selection.
Note 1:
Figure 3-21
Configure Satellite