E.8 debug commands – Lennox Hearth G8 User Manual
Page 136

Maintenance Port Parser Commands
54-0198
143
Configure Longitude of a User-configurable Satellite
Function:
configures one of the user-configurable satellites
with the longitude provided
Command:
SATCONFIG,USERX,YYY,Z,D,L
Response:
if valid pair, echoes the input data
if invalid pair, returns error message
Where:
X = 1 or 2
YYY = longitude (0-180)
Z = E (East) or W (West)
D = decoding type (0 = test, 1 = DSS-A,
2 = DSS-B, 3 = DVB)
L = LNB polarization (C = circular, L = linear)
E.8
Debug Commands
Report Offset Angles
Function:
reports system offset angles
Command:
OFFSETS
OFFSETS,XXXXX,YYYY
Response:
Offsets = XXXXX.X XXXXX.X
Where:
X = new azimuth offset (-1800 - 1800)
Y = new elevation angle (-450 - 450)
Apply Default Values to Default Satellites
Function:
updates the default satellites to the default values
Command:
SATPAIR,X
Response:
displays numerous frequency commands and
reports “Satellite Installation Complete”
Where:
X = 0 (satellites default to Astra1 & Hotbird)
or
X = 1 (satellites default to Expressvu and
Echo_119)
or
X = 2 (satellites default to DSS_101 and
DSS_119)
or
X = 3 (satellites default to Galaxy West and
None)
Table E-8
Debug Commands