Selecting active satellite, Setting the skew angle, Figure 3-18 select active satellite – Lennox Hearth G8 User Manual
Page 74: Figure 3-19 set skew angle menu

Selecting Active Satellite
After installing the active pair of satellites, use the Select Satellite
menu to choose which of the installed satellites will be active.
Setting the Skew Angle
The Set Skew Angle menu allows you to manually adjust the
skew angle of the antenna’s LNB.
Using the MCU Interface
54-0198
73
Proceed to "Setting the Skew Angle"
Select Satellite?
Enter
Next
Return
Select
Yes
Next
Cancel
Select
Yes
Next
cancel
Sat Name A
corresponds to the
first satellite selected
during the Install
Satellite process.
Sat Name B
corresponds to the
second satellite
selected during the
Install Satellite
process.
Figure 3-18
Select Active Satellite
Proceed to "Updating Satellite
Frequency Data"
Set Skew Angle?
Enter
Next
Return
Skew: ##.#
-
Enter
+
Enter the desired skew angle.
Use the -/+ keys to set each
number. Selecting ENTER will
cycle the display through each
digit, then return to "Set Skew
Angle."
Figure 3-19
Set Skew Angle Menu
European systems only:
If DiSEqC is active on your IRD,
once the antenna restarts, the
antenna starts tracking the satellite
currently selected by the IRD,
overriding the Select Satellite
command.