Lucent Technologies MERLIN LEGEND 6 - Manual (Page 323)

MERLIN LEGEND Communications System Release 6.0
System Manager’s Guide
555-660-118
Issue 1
February 1998
Managing the System
Page 6-93 Removing a CTI Link
6
extension, use the main extension number (for example, extension 12 in a
2-digit numbering plan), not the adjunct extension number (for example,
extension 712 in a 2-digit plan).
o
Follow the procedure in the preceding topic, “Busying-Out and Restoring
the MLX Module,” to restore service on the module where the CTI link is
located.
o
When you have finished, file Form 2a with the rest of the planning forms.
o
To install the server-related hardware associated with the link, contact your
Lucent Technologies representative.
Programming Instructions 6
Removing a CTI Link 6
Use this procedure to remove the programming for a CTI (Computer Telephony
Integration) link from an MLX port on a 008 or 408 MLX module. This
hardware/software feature is available in Release 5.0 and later systems operating
in Hybrid/PBX mode.
NOTE:
This topic describes only the last steps in adding a CTI link to the system.
Additional LAN-related procedures are described in the
PassageWay
Telephony Services Network Manager’s Guide.
Task List: Removing a CTI Link 6
o
Obtain Form 2a, System Numbering: Extension Jacks.
o
Record the new values on Form 2a.
o
If necessary, read “Auxiliary Equipment” in System Programming, Chapter
4, for additional information.
o
Open the System Programming menu from the console or a PC with SPM.
o
Follow the procedure outlined in “Busying-Out and Restoring the MLX
Module” on page 6–91 to terminate service on the module where the CTI
link is located.
Console Procedure 6ˆ‘@„ˆvƒ
→
8UDÃGvx
→
@‘‡r†v‚
→
Dial ext. no.
→
@‡r
→
@‘v‡
→
@‘v‡
PC Procedure
→
Е
→
Г
→
Type ext. no.
→ →
З
→
З