LSI U160 - Manual (Page 46)

3.75 pc 10.25 pc 11.25 pc 38.25 pc
4.333 pc
48.583 pc
52.5 pc
34.5 pc
44.25 pc
3-2 Configuring the LSIU160
you start the Configuration Menu. The subordinate menus are listed
below.
•
Adapter properties
•
Device properties
•
Adapter boot list
•
Global properties
All these properties are controlled by menus you access through the
configuration utility Main Menu. The Main Menu also gives an overview
of some properties of installed LSI Logic host adapter boards.
3.1.1 Starting the Configuration Utility
You can see the version number of your LSI Logic SCSI BIOS in a
banner displayed on your computer monitor during boot. If the utility is
available, the following message also appears on your monitor:
Press Ctrl-C to start LSI Logic Configuration Utility...
This message remains on your screen for about five seconds, giving you
time to start the utility. If you press “Ctrl-C,” the message changes to:
Please wait, invoking LSI Logic Configuration Utility...
After a brief pause, your computer monitor displays the Main Menu of the
LSI Logic SCSI BIOS Configuration Utility.
These messages may appear during the boot process:
•
“ Adapter removed from boot order, parameters will be
updated accordingly ” appears when an adapter is removed from
the system or relocated behind a PCI bridge.
•
“ Configuration data invalid, saving default
configuration! ” appears if none of the information in the NVRAM
is valid.
•
“ Found SCSI Controller not in following Boot Order List,
to Add: Press Ctrl-C to start LSI Logic Configuration
Utility... ” appears when less than four adapters are in the boot
order and more adapters exist than are shown.