Logical Solutions Secure Console Servers SCS-R - Manual (Page 73)

tel (203) 647-8700 Page 73 Product Manual - MAN-000001C
What Can A User Do S
ECURE
C
ONSOLE
S
ERVERS
To escape from interactive mode, the interactive mode escape sequence must be
used. The interactive mode escape sequence is a series of two to ten characters that
allow the user to leave interactive mode and return to the system prompt. The default
for the interactive mode escape sequence is
A (escape key, then uppercase
"A"), but the user may change the sequence by using the command editesc.
9.3.5 Break Sequence
The user is not directly connected to the server, but rather is connected through
the SCS, and therefore cannot use their ‘break’ key. While a user is connected to a port
in the interactive mode, the user can send a break signal to the port by entering a com-
mand to cause the Break sequence to occur.
The default value for this sequence is 'ESC - B'.
9.3.5.1 editbrk
When no in the interactive mode, a user can enter
editbrk
to edit or view their
preset break sequence. The break sequence (user key strokes, default is 'ESC - B') is
presented in its ASCII form (x1bB). If the user wishes to keep the existing sequence,
they need only to press to keep the existing setting.
Caution
It is generally best to have the sysadmin change the Break sequence,
as there may have been an equipment change or other issue that a
remote user might not be aware of.
9.3.6 Escape Sequence
A user-defined sequence of keys is used to leave the interactive mode.
The default value for this sequence is 'ESC - A'.
Note
It is best to NOT use combinations of the key and other keys
for the Escape sequence, as these combinations are usually reserved
for sending and receiving special characters through a terminal.