Logical Solutions Secure Console Servers SCS-R - Manual (Page 64)

System Administration
SCS160 / SCS320 / SCS480 Page 64 www.thinklogical.com
SCS160R / SCS320R
7.9.6 NIS Make file
The file Makefile.nis.portAccess is used to create the lsi port database.
To build the database, the above files (listed in Section 7.9, NIS and User Port Permis-
sions, on page 61) need to be loaded on the NIS server. The system has been tested on
a linux machine running RedHat 8.0. The files were placed in the
/var/yp
directory.
After the make file executed, the lsi database file was placed in the NIS host directory.
7.9.7 NIS Configuration File
The NIS configuration file (located at
/etc/nsswitch.conf
) must be edited
by the user to support your NIS server. To do this:
1. Open the file /etc/nsswitch.conf using your editor.
2. Edit (add or modify) a line to your config file that supports local files for local users,
and if not assigned locally, refers to the NIS database. The line should read:
port_access : files nis
3. Save your updated nsswitch.conf file.
7.10 NFS
NFS information can be obtained from the MAN pages. Refer to the following
man pages: nfs , mount , fstab .
This section is an overview of setup information for an NFS application, as it per-
tains to the SCS.
7.10.1 Remote NFS Directory
To mount a remote directory onto the SCS, you must start the portmap service
and the nfslock service.
To manually start these services (portmap and nfslock):
service portmap start
service nfslock start
You may have these services start automatically at power on. To do so, enter the
commands:
chkconfig portmap on
chkconfig nfslock on
Determine which local directory name you will use to refer to the remote directory.
The standard name used is /mnt . If you need more than one remote directory