Kicker SX900.4 - Manual (Page 35)

35
SX .4 Series Amplifiers
Specifica
tions
Performance
Model SX700.4 SX900.4
RMS Power @ 14.4 Volts
In Watts, All Channels Driven
4
Ω
Stereo, 1% THD 85 x 4 115 x 4
2
Ω
Stereo, 1% THD 175 x 4 225 x 4
4
Ω
Mono, 1% THD 350 x 2 450 x 2
Length With EndKaps 22.5” 25.75”
(57.15cm) (65.40cm)
Fusing 40A x 2 40A x 3
Recommended Power & Ground Wire 4 GA 1/0 GA
NOTE: All specifications and performance figures are subject to change. Please visit the support section at www.kicker.com for the most current information.
Power Wire Chart
Kicker Recommended
For Maximum Performance
Amperage
Draw
Up to
5 ft.
5 to
10 ft.
10 to
15 ft. 15 to
20 ft. 20 to
25 ft.
0-20
20-35
35-50
50-65
65-85
85-105
105-125
125-150
150-200
200-250
250-300
8 Ga. 8 Ga. 8 Ga. 8 Ga. 4 Ga.
8 Ga. 8 Ga. 8 Ga. 4 Ga. 4 Ga.
8 Ga. 8 Ga. 4 Ga. 4 Ga. 4 Ga.
8 Ga. 4 Ga. 4 Ga. 4 Ga. 1/0 Ga.
4 Ga. 4 Ga. 4 Ga. 1/0 Ga. 1/0 Ga.
4 Ga. 4 Ga. 1/0 Ga. 1/0 Ga. 1/0 Ga.
4 Ga. 1/0 Ga. 1/0 Ga. 1/0 Ga. 1/0 Ga.
1/0 Ga. 1/0Ga. 1/0 Ga. 1/0 Ga. 1/0 Ga.
1/0 Ga. 1/0 Ga. 1/0 Ga. 1/0 Ga. 1/0 Ga.
x 2
1/0 Ga. 1/0 Ga. 1/0 Ga. 1/0 Ga.
x 2
1/0 Ga.
x 2
1/0 Ga. 1/0 Ga. 1/0 Ga.
x 2
1/0 Ga.
x 2
1/0 Ga.
x 2
* For current draw exceeding 300 amps or cable lengths in excess
of 25 feet contact Kicker or your local Kicker dealer for advice.
Model SX700.4
85 x 4 @ 4 ohms, 14.4Vdc, 1% THD,
CEA-2006 (Watts)
Signal to Noise Ratio in Bypass Mode -75
CEA-2006 (ref: 1W, A-weighted)
Model SX900.4
115 x 4 @ 4 ohms, 14.4Vdc, 1% THD,
CEA-2006 (Watts)
Signal to Noise Ratio in Bypass Mode -70
CEA-2006 (ref: 1W, A-weighted)