Kicker SX900.4 - Manual (Page 18)

18
SX .4 Series Amplifiers
Opera
tion
9.) Mem Name - Here you can change the names of the
memory locations. The factory defaults are
Memory-1
Memory-2
Memory-3
Memory-4
Use the UP and DOWN keys to select the memory
location name you want to change and then press the
ENT
key to select it.If you change your mind and do not
want to change the name, press and hold the
HOME
key
for 1.5 seconds BEFORE making any changes.
The
ESC
and
ENT
keys move the
cursor left or right to select which
character to change.
Use the
UP
and
DOWN
keys to
change the character displayed
(A, B, C...1, 2, 3...etc)
When you are finished press and hold
the
HOME
key for 1.5 seconds to save
your new memory name.
Repeat the above steps to rename the other presets.
HOME ENT ESC
HOME ENT ESC
HOME ENT ESC
HOME ENT ESC
PRESS &
HOLD
10.) REMOTE CTL - Here you select which amplifier is
controlled by the Remote Bass Level Controller. The options
are
BOTH AMPS , AMP-1 ONLY and AMP-2 ONLY .
Use the
UP
and
DOWN
keys to
select which option you want to use
and press the
ESC
key to return to
the SYSTEM menu.
11.) Remote Adr - This feature is currently not used but is
reserved for future expansion.
12.) Gain Range - Sets the input voltage window of the
UltraMatch gain control. The options are:
1V, 2V, 4V, 8V, 16V
Select the one closest to the maximum RCA input voltage
you expect to send to the amplifier.
Use the UP and DOWN keys to
select your voltage. Press the
ESC
to return to the MAIN menu.
13.) Bypass DSP - Bypasses all DSP
processing and sends the input signal directly to the
amplifier.
Use the
UP
and
DOWN
keys to
select BYPASS ON or BYPASS OFF .
Press the ESC key to return to
the MAIN menu.
HOME ENT ESC
HOME ENT ESC
HOME ENT ESC