Kenwood KDV-MP6333 EN - Manual (Page 65)

English 65
Help?
2ZON (Dual zone)
The dual zone function splits the output of the main
source and sub source between the front speaker and
rear speaker.
OFF : Dual zone function is off.
DVD : DVD is set as the sub source.
AUX : AUX is set as the sub source.
• Output destination of sub source is specified using
"ZONE2" in the
• The main source is specified using
source> (page 13).
• Front speaker volume is adjusted using the [VOL]
button.
• Rear speaker volume is adjusted by "R-VOL" in the
section (page 36) or by
using the [R.VOL] key (page 55) on the remote
control.
Menu
AMP (Built-in amp output)
Output from the built-in amp is turned ON and OFF.
When there is a system where power amps are
connected to the preamp output terminals of both the
front speaker and the rear speaker, operation of the
built-in amp can be stopped by turning this function
"OFF".
The quality of audio output from the preamp outputs
can be improved by stopping operation of the built-in
amp.
AMP CTRL
You can perform various settings for the optional
power amplifier that is connected by LX cable.
In addition, since the various information on the power
amplifier including voltage, consumption current,
internal temperature, the number of rotations for
the electric fan, etc. is displayed, you can instantly
check the conditions in which the power amplifier is
operating.
For details of the items you can control, refer to the
operation manual of the LX amplifier.
AUX (Internal AUX input)
(KDV-MP6333 only)
The AUX terminal inputs audio from external devices
such as video players and car navigation systems to
this unit.
This function turns audio input to the internal AUX
terminal ON and OFF.
When this function is ON, audio input to the AUX
terminal can be heard from this unit by switching to
the AUX source.
By using the dual zone function it is also possible to
output another source simultaneously.
Turn OFF when not in use.
BEEP (Beeping)
This function produces a beeping sound when
pressing a button to confirm that the button has been
pressed.
If you find this beeping sound annoying, you can get
rid of it by turning it "OFF".
Please note that this beeping sound does not come
out of preamp outputs.
BMS
With this function, you can control the amplification
amount for the bass range of the optional power
amplifier with B.M.S functions that is connected by EXT.
CONT. cable.
Values to be changed and the operation of the
amplifier during the change may differ according to
the amplifiers. For details, refer to the operation manual
of the connected power amplifier.
For the amplifier with B.M.S function, refer to the
catalog.
BMS F
This function adjusts the central frequency of the bass
amplification being set by "BMS".
Setting at "LOW" reduces the frequency by 20-30%.