Kenwood KDV-MP6333 EN - Manual (Page 38)

38 KDV-MP6333/KDV-MP6433
2 Set to the speaker matching mode
EQ AM SETUP AUD
VOL
ATT
MENU SCAN STOP M/S RDM REP F.SEL M.RDM
DISP SW
AME TI FM SCRL
SRC
3 Select a speaker
EQ AM SETUP AUD
VOL
ATT
MENU SCAN STOP M/S RDM REP F.SEL M.RDM
DISP SW
AME TI FM SCRL
SRC
Each time the knob is rotated, the indication
changes in the following order.
Display Speaker type
"SP OFF" OFF
"SP 5/4" For 5 & 4 in. speakers
"SP 6*9/6" For 6 & 6x9 in. speakers
"SP OEM" For OEM speakers
4 Exit the speaker matching mode
EQ AM SETUP AUD
VOL
ATT
MENU SCAN STOP M/S RDM REP F.SEL M.RDM
DISP SW
AME TI FM SCRL
SRC
Subwoofer output control
Turns the subwoofer output ON/OFF.
(Subwoofer ON) SW ON
SW OFF (Subwoofer OFF)
• Cannot be set when the dual zone function is activated.
• The subwoofer can be turned ON/OFF when the feature
"SWPRE" in
System Q
Shows the equalizer curve for the song being
played.
1 Select the desired source
Q AM SETUP AUD
VOL
MENU SCAN STOP M/S RDM REP F.SEL M.RDM
OFF
DISP SW
SRC
2 Recall the System Q
Q AM SETUP AUD
VOL
MENU SCAN STOP M/S RDM REP F.SEL M.RDM
OFF
DISP
SW
SRC
Each time the button is pressed, the type
changes in the following order.
Display Setting
"USER" User
"ROCK" Rock
"POPS" Pops
"EASY" Easy
"TOP40" Top 40
"JAZZ" Jazz
"NATURAL" Natural
• The System Q can be set for each source.
• The System Q value varies depending on the settings
made in the (page 38). Perform the
in advance.
• "USER" is the value that was set the
quality and others> (page 11).
• If the System Q setting is changed, the values ("BAS L",
"MID L", and "TRE L") set in the others> are replaced with the System Q value.
Speaker setup
Fine adjust the System Q value to the speakers.
1
Set to STANDBY mode
EQ AM SETUP AUD
VOL
MENU SCAN STOP M/S RDM REP F.SEL M.RDM
OFF
DISP SW
SRC
STANDBY
Select "STANDBY".
Audio Control : Press for # seconds.