Kenwood KDV-MP6333 EN - Manual (Page 61)

English 61
General
? The power does not turn ON.
✔ The fuse has blown.
After checking for short circuits in the wires,
replace the fuse with one with the same
rating.
✔ The speaker wire has a short-circuit or
touches the chassis of the vehicle, and then
the protection function is activated.
Wire or insulate the speaker cable properly
and press the Reset button.
✔ A security code has been set.
Enter the set security code (page 47).
? No sound can be heard, or the volume is low.
✔ The fader or balance settings are set all the
way to one side.
Center the fader and balance settings.
✔ The "AMP" feature in Menu setup is "OFF".
Turn the "AMP" feature "ON", referring to
✔ The values for Volume offset are too low.
Turn up the Volume offset, referring to the
section (page 37).
✔ The input/output wires or wiring harness are
connected incorrectly.
Reconnect the input/output wires or
the wiring harness correctly. Refer to the
section (page 70).
? The sound quality is poor or distorted.
✔ One of the speaker wires is being pinched
by a screw in the car.
Check the speaker wiring.
✔ The speakers are not wired correctly.
Reconnect the speaker wires so that each
output terminal is connected to a different
speaker.
? The TEL mute function does not work.
✔ The TEL mute wire is not connected
properly.
Connect the wire correctly, referring to the
section (page 70).
? The TEL mute function turns ON even
though the TEL mute wire is not connected.
✔ The TEL mute wire is touching a metal part
of the car.
Pull the TEL mute wire away from the metal
part of the car.
? The memory is erased when the ignition is
turned OFF.
✔ The ignition and battery wire are incorrectly
connected.
Connect the wire correctly, referring to the
section (page 70).
? There’s no loudness effect.
✔ You are using Subwoofer preout.
Loudness has no effect in Subwoofer preout.
? Even if Loudness is turned ON, high-pitched
tone is not compensated for.
✔ Tuner source is selected.
High-pitched tone is not compensated for
when in Tuner source.
? Radio reception is poor.
✔ The car antenna is not extended.
Pull the antenna out all the way.
✔ The antenna control wire is not connected.
Connect the wire correctly, referring to the
section (page 70).
? There is a source you cannot switch.
✔ The Disc changer is not connected.
Connect the Disc changer. If the Disc
changer is not connected to it’s input
terminal, You can’t switch to an external disc
source.
? The display blacks out while scrolling.
✔ The "DISP" feature under
"OFF".
Turn the "DISP" feature "ON", referring to the
Help?
Troubleshooting
Help?