Kenwood KDV-MP6333 EN - Manual (Page 37)

English 37
A
udio C
o
n
tr
o
l
The setting range of each feature is as follows:
Feature Setting range
BAS F 40/50/60/70/80/100/120/150 (Hz)
BAS Q 1.00/1.25/1.50/2.00
B EX OFF/ON
MID F 0.5/1.0/1.5/2.0 (kHz)
MID Q 1.0/2.0
TRE 10.0/12.5/15.0/17.5 (kHz)
4 Exit the detailed settings
Q AM SETUP AUD
VOL
ATT
MENU SCAN STOP M/S RDM REP F.SEL M.RDM
DISP SW
AME AUTO FM SCRL
SRC
• For each adjustment feature, see (page 64).
• Setting audio control will set the System Q to "USER". For
System Q, refer to (page 38).
Audio setup
Sets up volume offset, dual zone function, etc.
1 Start audio setup
Q AM SETUP AUD
VOL
ATT
MENU SCAN STOP M/S RDM REP F.SEL M.RDM
DISP SW
AME AUTO FM SCRL
SRC
2 Select features to set
Q AM SETUP AUD
VOL
ATT
MENU SCAN STOP M/S RDM REP F.SEL M.RDM
DISP
SW
AME AUTO FM SCRL
SRC
Each time the knob is pressed, the type
changes in the following order.
Feature Setting range
HPF Specifies the front high-pass filter cutoff frequency.
HPR Specifies the rear high-pass filter cutoff frequency.
LPF Specifies the low-pass filter cutoff frequency.
PHAS Specifies the subwoofer phase.
V-OFF Adjusts the volume difference between sources.
LOUD Corrects treble and bass when the volume is low.
AVOUT Specifies the output level of the AV OUT terminal.
2ZON Turns the dual zone function ON/OFF.
3 Set up each feature
Q AM SETUP AUD
VOL
ATT
MENU SCAN STOP M/S RDM REP F.SEL M.RDM
DISP
SW
AME AUTO FM SCRL
SRC
The setting range of each feature is as follows:
Feature Setting range
HPF/HPR THRU (Filter Off)/40/60/80/100/120/150/
180/220 (Hz)
LPF 50/60/80/100/120 (Hz)/THRU (Filter Off)
PHAS REV (180˚)/NML (0˚)
V-OFF -8 – 0
LOUD OFF/ON
AVOUT -15 – 0
2ZON OFF/DVD/AUX
4
Exit audio setup
Q AM SETUP AUD
VOL
ATT
MENU SCAN STOP M/S RDM REP F.SEL M.RDM
DISP SW
AME AUTO FM SCRL
SRC
• If a volume offset is set for each source with "V-OFF", the
volume will be nearly the same for all sources when the
source is changed.
• KDV-MP6433:
You can select "AUX" for "2ZON" only when CA-C1AX/CA-
C2AX (optional accessory) is connected.
• When "2ZON" is ON ("DVD"/"AUX"), you can only set "V-
OFF" and "LOUD".
• If the dual zone function is used, different sources can be
output from the front speakers (source of this unit) and
the rear speakers (disc source of this unit or the sound
input to the AUX).
• For "LPF" and "PHAS", the feature "SWPRE" needs to
be set to "SW" (subwoofer) in the menu setup, and
the subwoofer output to ON. For details on how to set
up "SWPRE", refer to
• "PHAS" cannot be set up when "LPF" is set to "THRU".
• "AVOUT" can be set when the feature "SWPRE" in
setup> (page 44) is set to "AV".
: Press for # seconds.