Kathrein MSK 125 - Manual (Page 36)

36
CHANNEL DISPLAY AND ENTRY
To measure the level of a reception signal, you must fi rst enter
the desired channel.
The following channels can be set:
• Band I/III
CH 01 to CH 12 in 7 MHz raster
• Band IV/V CH 21 to CH 69 in 8 MHz raster
• Special channel S 01 to S 20 in 7 MHz raster
• Special channel S 21 to S 41 in 8 MHz raster
These details refer to the default Standard B/G only. For
information on the other standards please see the technical
appendix.
TV MEASUREMENT
COMMAND OVERVIEW FOR TV CHANNEL ENTRY
Switch to desired TV reception
... Enter channel
Confi rm entry
... Enter channel (automatic
confi rmation)
Switch to special channel
and Change channels in intervals
or
or
Example
To enter channel S 28:
Press
.
LC display:
• Special channel: S 28
• Level: 62.5 dBµV
• Operating mode: Analogue cable TV (A=analogue)
Ensure that the correct standard has been set. The default setting
is Standard B/G.
Note
FREQUENCY DISPLAY AND ENTRY
To measure the level of a reception signal, you must fi rst enter
the desired video carrier frequency.
The frequency can be entered from 47 MHz to 862 MHz in 50 kHz
intervals.