Kathrein MSK 125 - Manual (Page 20)

20
“SAT ANALOGUE” LEVEL MEASUREMENT
After you have set a frequency the level is measured automatically
and indicated on the LC display in dBµV or dBmV (depending on
the basic confi guration). The input level can be measured in the
range of 30 dBµV to 120 dBµV (-30 dBmV to 60 dBmV).
LC display:
• Frequency: 1508.0 MHz
• Operating mode: SAT analogue
• Measured level: 86.5 dBµV
Level overfl ow and underfl ow
At a level < 30 dBµV the LC display indicates an underfl ow.
The following details are displayed:
• Frequency: 1508.0 MHz
• Operating mode: SAT analogue
• Level: underfl ow
At a level > 120 dBµV the LC display indicates an overfl ow.
The following details are displayed:
• Frequency: 1508.0 MHz
• Operating mode: SAT analogue
• Level: Overfl ow
The level of DVB-S(2) signals can only be measured properly
with the setting “SAT digital reception”.
Note
Every analogue satellite video signal has multiple audio carrier
frequencies assigned. On the MSK 125 you can listen to main and
sub-audio carriers you choose. The audio carrier frequency can be
adjusted from 5.0 MHz to 8.99 MHz in 10 kHz intervals. At 7.00 MHz
the sound carrier bandwidth is automatically switched from “wide”
(280 kHz) to “narrow” (150 kHz).
By default the following sound carrier frequencies are stored:
SOUND CARRIER FREQUENCY SETTING
SAT