KORG TRITON STUDIO V2 - Manual (Page 64)

59
Disk
Global
Sampling
Combination
Program
Other functionality
If “Save to” is set to DISK, you can use the page menu
command “Select Directory” (0–1N
☞PG p.96) to spec-
ify the save-destination for the WAVE file that will be
created by sampling.
■ Sampling
8 Press the SAMPLING [REC] key and then the SAM-
PLING [START/STOP] key
.
9 Play the instrument etc. that is connected to the AUDIO
INPUT jack you specified in “Source Audio.”
0 When you are finished playing, press the SAMPLING
[START/STOP] key
.
■ Listen to the sampled data
• If you selected “Save to: RAM,” play the C2 key to hear
the sample.
• If you selected “Save to: DISK,” use the page menu
command “Select Directory” (0–1N ☞PG p.96) to hear
the sample.
3. Auto Resample through IFX
This automatically makes the appropriate settings for auto
resampling through the insert effects (IFX).
■ Setup
1 Select “Auto Sampling Setup” to open the dialog box.
2 Use the radio buttons to select Auto Resample through
IFX
.
3 Use “IFX” to select the insert effect that you want to use
for auto resampling.
4 Press the OK button to execute “Auto Sampling Setup.”
If you decide not to execute, press the Cancel button.
(For the automatically-set parameters and their values,
☞p.60. For examples of using the automatically-set
parameters, refer to
☞BG p.107)
■ Resample
5 Specify the Key assigned to the sample that you want to
resample. (
☞PG p.98)
6 Make settings for the insert effect. To check the sound,
press the key that you specified in Key.
7 Press the SAMPLING [REC] key and then the SAM-
PLING [START/STOP] key
.
The sample will automatically play back, and resampling
will begin. When the sample finishes playing, resampling
will also end.
■ Check the resampled data
• Play the key you specified in Key.
To prevent the insert effect from being applied “in
duplicate” when you listen to the resampled data, “BUS
(IFX) Select” (P8 8–1b
☞PG p.122) will automatically be
set to L/R when resampling ends. If you want to apply
IFX and resample once again, you will need to change
this setting back to the same IFX.
Use “Bank” (0–1c ☞PG p.90) to specify the sampling-
destination sample memory (RAM).
Add the contents of “0–1O: Auto Sampling Setup” to the
explanation in “Parameter Guide” 0–1 Recording Page Menu
Command (
☞PG p.92).