KORG TRITON STUDIO V2 - Manual (Page 37)

32
Automatically-set parameters and their values
-: Not set automatically
Settings enclosed in parentheses ( ) are set automatically according to the parameters in the dialog box.
*1 : The specified setting for Analog, S/P DIF, or mLAN (“Input1” or “Input2”) will be made automatically.
*2
: The input source setting (“Input1” or “Input2”) specified in the “Source Audio” field of the dialog box will be made automat-
ically.
*3 : If “Source Audio” is Mono-1 this will be L-Mono, if Mono-2 it will be R-Mono, and if Stereo this will be Stereo.
*4
: If “Save to” is RAM, and “Convert to Program” is On.
When you select and execute In-Track Sampling, the track selected in “To” will automatically be set to a “Status” ( ☞PG
p.62) of BTH.
Parameter 1. Initialize 2. Resample SEQ Play 3. In-Track Sampling
Input (Input Source) (Analog, S/P DIF, mLAN) *1 (Analog, S/P DIF, mLAN) *1 (Source Audio) *2
Input1 Level 127 127 127
Pan L000 L000 L000
BUS Select Off Off 1/2
Send1 000 000 000
Send2 000 000 000
Input2 Level 127 127 127
Pan R127 R127 R127
BUS Select Off Off 1/2
Send1 000 000 000
Send2 000 000 000
Sampling Setup Source BUS L/R L/R Indiv.1/2
Trigger Sequencer START SW Note On Sampling START SW
Save to RAM (Save to) RAM
Mode Stereo Stereo (Source Audio) *3
Sample Time: RAM Maximum - -
Sample Time: DISK 4min 59.999sec - -
Recording Level [dB] –12.0 –12.0 +0.0
Select Bank & Smpl No.
(Page Menu Command) Auto +12dB On On On Off
Convert to Program Off (Convert to Program) On
Program - (Program) (Program)
MS - Newly created *4 Newly created *4
Orig.Key - C2 *4 C2 *4
Seq.Event Off Off On
Track - - (To)
Recording Setup (Audio Track) Track Select - - -
Punch In Off - -
Bounce Off - -
Source BUS L/R - -
Overwrite.WAV Off - -
Sel Dir/WAVE (Audio Track) for
Audio Track
(Page Menu Command)
WAVE File - - -
Audio Track Audio1 SOLO - - -
Pan - - -
Audio2 SOLO - - -
Pan - - -