Controlling ess, Adjusting the sensitivity of the pedal, Djusting – KORG Ax3000b User Manual

Page 51: Sensitivity, Pedal

Introduction

Panel Tour

Setup

Playing

Creating

and Storing

Effect Type

Pedals

ESS

Index

MIDI/DIGITAL

Factory

settings

Trouble-

shooting

Spec.

Tuner

Appendix

ONTROLLING

ESS

NOTE: ESS TAP1, ESS TAP2, and ESS TRIG will do nothing if the SPEED of the
step effect is set to PEdL.

NOTE: ESS CTL2, ESS TAP1, ESS TAP2, and ESS TRIG will do nothing if ESS is
turned off.

NOTE: For ESS TAP1 and ESS TAP2, the CONTROL switch LED will blink at the
specified tempo.

NOTE: The maximum tap interval is 10 seconds.

DJUSTING

THE

SENSITIVITY

THE

PEDAL

If you notice that advancing the AX3000B’s expression pedal does not reach the full
effect or volume even when the Min and Max parameters are set to the minimum
and maximum settings, or that returning the expression pedal does not reach the
minimum effect or volume, you will need to perform the following adjustment so that
the AX3000B’s expression pedal will be able to reach its full range of operation.

NOTE: When adjusting the sensitivity, you should use your hand to operate the
pedal. Accurate adjustment may not be possible if you use your foot.

1. Turn the power OFF.

2. While holding down the EXP/CTL button and the

▲ button, turn the power on.

The name display indicates EXP MAX.

3. Slowly return the expression pedal toward yourself (pedal back), and take your

hand off the pedal when it stops.

NOTE: If you decide to cancel the calibration procedure, press the EXIT button.

4. Press the WRITE button. The name display indicates EXP MIN.

• “ESS CTL1”

Turn ESS on/off

• “ESS CTL2”

Turn the effect being controlled by ESS on/off

• “ESS TAP1”

Use tap tempo to specify the duration until the next step

• “ESS TAP2”

Use tap tempo to specify the length from step 1 until the
last step (if in Alternate mode, the length of one cycle
back to step 1)

• “ESS TRIG”

The sequence will begin from step 1

Press slowly

Name display