KORG Ax3000b - Manual (Page 12)

6
3.1 AMP/LINE button
This button lets you make appropriate settings for the device to which your
AX3000B is connected. The icon in the display will change depending on
the destination device you’ve selected (p.12).
3.2 GLOBAL button
You can press the GLOBAL button and use the √ √ √ √ / ® ® ® ® buttons to move through
the menus in the following order. After you’ve selected a menu item, use value
knob 1 or the
▲
/
▼
buttons to edit the value.
3.3 WRITE button
Use this button when you want to save the settings you’ve created (p.19).
3.4 EXIT/TUNE button
Use this button to cancel a “program save” operation or a setting you ’ ve made.
If the name display shows a program name, pressing this button will start up the
built-in Tuner. By pressing and holding down this button, you can enable or dis-
able the Key Lock function, which disables operation of the buttons, selectors,
and knobs (p.16, 21).
D ISPLAY /C URSOR SECTION
This area displays the program name, and the name and value of the parame-
ters you’re editing in the amp or effect section.
4.1
▲/▼ buttons
Use these to edit the value of parameters.
MIDI CH: MIDI channel setting (p.51)
PCHG OUT: Program change message output setting (p.51)
CCHG I/O: Control change message input/output setting (p.51)
SYEX OUT: System exclusive message output setting (p.52)
DUMP CUR: Send the current program data from the MIDI OUT jack (p.53)
DUMP ALL: Send all of the AX3000B’s data from the MIDI OUT jack (p.53)
DOUT LVL Set the S/P DIF output level in a range of five levels;
–12, –6, 0, +6, +12 [dB]