Kenwood DNX7340BTM - Manual (Page 63)

English 63
Monitor Angle Control
You can adjust the position of the monitor.
Display the Angle Setup screen 1
Touch [ ] > [ ] > [System] > [Angle].
(page 58)
Set the Monitor Angle 2
1 1 1
1 Sets the Monitor angle.
[Memory] Stores the current monitor angle as
the angle during power off.
EXT SW Setup
Setting up power specification of the external
device for which the power is controlled from this
unit. (DNX/ DDX7 models only)
Display the 1 EXT SW Setup screen
Touch [ ] > [ ] > [System] > [EXT SW].
(page 58)
Perform EXT SW Setup 2
[SW Name] Sets the name of the external
device. See (page 41) for
information on how to enter the name.
[Output Pattern] Sets the power signal output
mode.
(
EXT SW1: Pulse, EXT SW2: Level)
"Pulse": Generates a single power signal pulse.
"Level": Continues output of high power signal.
Sets to turn output on/off each time
the button on the EXT SW Control
screen is touched.
[Pulse Set] Sets the Pulse signal output time.
Outputs 500ms when "1" is set. Increases by
200ms with each step. Up to 100 steps can
be set.