Kenwood DNX7340BTM User Manual
Page 55
English 55
Tone Setup (DDX6 models)
You can set a Tone curve.
Display the Equalizer screen
1
Touch [
]
>
[
]
>
[Equalizer]. (page 53)
Display the Tone Control screen
2
Set the Tone
3
[Bass] Bass adjustment items are displayed.
[Middle] Middle adjustment items are
displayed.
[Treble] Treble adjustment items are displayed.
[Flat] Tone level becomes 0 (flat).
[FREQ] Sets the Center frequency.
[Level] Sets the level.
[Q Factor] Sets the Q factor. (Only [Bass] and
[Middle] can be set)
[Bass DC EXT] Bass DC Extend settings. (Only
[Bass] can be set)
If turned "ON", it extends the bass center
frequency to the low register by approximately
20%.
[SW Level] Adjusts the subwoofer volume.
Zone Control
You can set the front and rear audio source.
Display the Zone Control screen
1
Touch [
]
>
[
]
>
[Zone Control]. (page 53)
Set the Zone Control
2
[Single Zone] Turns off the dual zone.
[Front Source] Sets the front audio source.
[Rear Source] Sets the rear audio source.
⁄
When the rear speaker sound is switched, the audio
•
source that is output at the AV OUTPUT terminal is
also switched to the same source.
[Rear VOL.] Adjusts the volume of the rear
channel.
⁄
There are following limitations when zone function is set
•
to "ON".
- There is no output from the subwoofer.
-
56),
71),