Kenwood HM-DV7 - Manual (Page 9)

9
System connection
Preparation section
The feet of the provided speaker can be replaced as required.
1
Remove the four feet on the front and rear
part of the bottom panel using a screwdriver.
2
Attach the feet to the specified positions on
the side panel. (Use the screws removed in
1 for attaching.)
Replacing the feet with the provided feet
÷ Do not install the subwoofer without feet.
Channel space setting (Except for U.K., Europe and Australia)
The space between radio channels has been set to the one that prevails in the area to which the system is shipped.
However, if the current channel space setting does not match the setting in the area where the system is to be
used, for instance when you move from area 1 or area 2 shown in the following table or vice versa, proper recep-
tion of AM/FM broadcasts cannot be expected. In this case, change the channel space setting in accordance with
your area by referring to the following table.
CHANNEL
Space Frequency
Area
1
2
USA, Canada and South
American countries
Other countries
FM: 100 kHz
AM: 10 kHz
FM: 50 kHz
AM: 9 kHz
1
Select the "TUNER" input.
2
Press the STOP
7/TUNING MODE key.
(for more than 5 seconds)
Each press switches the space frequency alter-
nately.
1 FM 50 kHz, AM 9 kHz
2 FM 100 kHz, AM 10 kHz
Main unit only
STOP 7
TUNING MODE
TUNER/ BAND