Kenwood HM-DV7 - Manual (Page 6)

6
System connection
Preparation section
GND FM75 Ω
AM
ANTENNA
1 2 3
System connection
AM loop antenna
The supplied antenna is for indoor use. Place it as far
as possible from the main system, TV set, speaker
cords and power cord, and set it to a direction which
provides the best reception.
Connect the antenna as shown in the figure.
Do not plug the power cord into a wall AC outlet until the connection has been completed.
Connection of the System Accessories
FM indoor antenna
The accessory antenna is for temporary indoor use only.
For stable signal reception we recommend using an out-
door antenna.
Remove the indoor antenna if you connect one outdoors.
FM indoor antenna
AM loop
antenna
Connection of the Accessory Antenna
FM outdoor antenna (Commercially available)
Lead the 75
Ω
coaxial cable connected to the FM out-
door antenna into the room and connect it to the FM
75
Ω
terminal. Please remove the indoor antenna after
an outdoor antenna has been installed.
FM outdoor
antenna (Commer-
cially available)
75
Ω
coaxial cable
(Commercially available)
Antenna adaptor
(Commercially available)
GND FM75 Ω
AM GND AM
ANTENNA
Malfunction of microcomputer
If operation is not possible or erroneous display appears even though all connections have been made
properly, reset the microcomputer referring to "In case of difficulty". ˆ
1 2 3 4
Assembling the antenna
1
Connect the antenna to the antenna termi-
nal.
2
Locate the position providing good recep-
tion condition.
3
Fix the antenna.