Kenwood DVT-6200 - Manual (Page 56)

56
Knowledge
DVT-6200 (EN/K,E,X)
In case of difficulty
Operation to reset
What appears to be a malfunction may not always be serious. If your unit should not perform as expected, consult the
table below to see if the problem can be corrected before seeking help from your dealer or service representative.
1
Press the MENU key on the remote to enter SETUP
MENU.
2
Select the PREFERENCE, then press the ENTER key.
3
Select DEFAULTS, press the Cursoe right ( 3) key to
select RESET.
4
Press the numeric keys as shown below.
Press
1, 3, 9, 7, then press the ENTER key.
When resetting is done according to this method, all set-
tings, including the settings for password and parental level,
will be reset to the factory defaults.
The microprocessor may fall into malfunction (impos-
sibility to operate erroneous display, etc.) when the
power cord is unplugged while power is ON or due to
an external factor.
In this case, switch off the power, wait for several sec-
onds, and then switch the power on again.
Return to the factory defaults by resetting the micropro-
cessor is done as shown as follows.
÷ Connect properly referring to “System con-
nections”.
÷ Switch MUTE OFF.
÷ Unplug the headphone plug.
÷ Connect properly referring to “System con-
nections”.
÷ Connect antennas.
÷ Select a band.
÷ Tune to the frequency of the desired sta-
tion.
÷ Install the outdoor antenna in an apart posi-
tion from the road.
÷ Switch the suspected electric appliance OFF.
÷ Install the TV or the system at an increased
distance between them.
÷ Preset stations with tunable frequencies.
÷ Preset stations again.
÷ Check the speaker connection.
÷ Check the speaker connection. If this does
not help, contact your dealer for service.
÷ Select Surround with the LISTEN MODE
key.
÷ The speaker cords are disconnected.
÷ The MUTE switch of remote control unit is
switched ON.
÷ The headphone plug is inserted into the jack.
÷ The speaker cords are disconnected.
÷ The antennas have not been connected.
÷ A proper broadcasting band has not been se-
lected.
÷ The frequency of the station to be received is
not tuned.
÷ Car ignition noise.
÷ Influence of an electric appliance.
÷ A TV set is installed near the system.
÷ The frequency of the preset station is not
tunable.
÷ The preset memory has been cleared because
the power cord has been unplugged for a long
period.
÷ The speaker connection is abnormal.
÷ The LISTEN mode is STEREO.
Sound is not produced.
Sound is not produced from the left
or right speakers.
Radio stations cannot be received.
Noise interferes.
A station has been preset but it can-
not be received by pressing the
P.CALL key.
The STANDBY indicator flashes red.
No sound from the surround speakers
Remedy Cause Symptom
Receiver, speakers
!
›
›
!
@
fl
fl
@
‡
ª
03.7.8, 11:04 AM Page 56