Kenwood DVT-6200 - Manual (Page 13)

13
Preparations
DVT-6200 (EN/K,E,X)
Connecting to a TV
Connecting to a Satellite Tuner
COMPONENT Video cord
* COMPOSITE Video cord
(accessory)
S-Video cord
Audio cord
COMPOSITE
video cord
**COMPONENT connection corresponds only to some areas.
When the TV has a COMPONENT terminal, the DVD image will be played
back with higher picture quality in case of COMPONENT connection.
Connect the S-video or the COMPOSITE video cable also in this case.
Select the scanning method of the Component Video output using the
PROGRESSIVE (ACTIVE EQ.) key on the front panel.
Note Note Note
* For Europe only
If your TV set has a SCART terminal,
connect the accessory SCART plug to
the SCART terminal of the TV and
connect the COMPOSITE video cord.
TV
Satellite tuner
System Connections
Note Note Note
**0nly for
some areas.
Depressed and keep pressing the key. Each time
the key is being held down, the setting changes
as follows.
1 ON
2 OFF
ON: When progressive scanning is unavailable with certain discs, the scanning
method is switched automatically to interlaced scanning. When the scanning
method is changed, the scanning status will be displayed for a few seconds.
OFF: Scanning method is fixed at interlaced scanning.
Example for some areas
The S-Video output terminal of this unit is only for output of the built-in
DVD player. The output of equipment connected to VCR, CABLE/SAT is put
out as a composite signal.
03.7.8, 11:05 AM Page 13