Kenwood DVT-6200 - Manual (Page 30)

DVT-6200 (EN/K,E,X)
Set Up functions
30
Preparations
1 Press SET UP key for more than 3
seconds
2 Press the TRIM (5/∞) keys to con-
trol the speaker level.
C
SW
LS RS
L R
Front speaker
Front speaker
Sub woofer
Center speaker
Surround
speaker
Surround
speaker
Positioning the speakers
To achieve the optimum effects obtainable with this SURROUND SOUND system, it is important to position the speakers
properly. Refer to the following illustration to find the best location in your room.
Speaker setting
Preparation
Turn on the POWER.
Speaker level setting
For this unit, the speaker levels have been set in advance so that the best volume balance is obtained with
standard use.
Initial set values for the speaker level
Left Front channel (Lch)(L) : 0dB
Center channel (Cch)(C) : 0dB
Right Front channel (Rch)(R) : 0dB
Right Surround channel (RSch)(RS) : 0dB
Left Surround channel (LSch)(LS)
: 0dB
Subwoofer(SW) : 0dB
Reset as follows to match your listening environment.
The test tone is played back from the Left Front speaker.
Adjust the VOLUME CONTROL so that it is slightly loud
and fix it there.
“L” Blinks.
L → C → R → RS → LS → SW
The speakers will be switched as follows in intervals of
about 2 seconds.
÷ After all speakers have been adjusted, operate the
Delay time setting ( ⁄).
Adjust the volume with the TRIM ( 5/∞) keys while the
indicator is flashing so that the volume from all speakers
except the subwoofer (SW) appears the same. Level ad-
justment is possible in the range from -10 dB to +10 dB.
Note Note
As the subwoofer (SW) has a special playback band, nor-
mal adjustment is not possible with the test tone. Please
adjust the subwoofer while listening to actual music. (
¤)
03.7.8, 11:06 AM Page 30