Audio setup – Kenwood DPX701 DPX501 User Manual
Page 13
English
|
13
3
Select the Detail Audio item to adjust
Press the [VOL] knob.
Each time you press the knob, the item to be
adjusted alternates between the items shown in
the table below.
4
Adjust the Detail Audio item
Turn the [VOL] knob.
Bass level
Adjustment Item
Display
Range
Bass Center Frequency
"Bass FRQ"
40/50/60/70/80/100/
120/150 Hz
Bass Q Factor
"Bass QFactor" 1.00/1.25/1.50/2.00
Bass Extend
"Bass EXT"
OFF/ON
Middle level
Adjustment Item
Display
Range
Middle Center Frequency "Middle FRQ" 0.5/1.0/1.5/2.0 kHz
Middle Q Factor
"Middle
QFactor"
1.00/2.00
Treble level
Adjustment Item
Display
Range
Treble Center Frequency "Treble FRQ"
10.0/12.5/15.0/17.5 kHz
5
Exit the Detail Audio Control mode
Press the [VOL] knob for at least 1 second.
• When you set the Bass Extend to ON, low frequency
response is extended by 20%.
• You can exit the Audio Control mode at anytime
by pressing any button except for [VOL] and [ATT]
buttons.
Audio Setup
Setting the Sound system, such as Cross over
Network.
1
Select the source to adjust
Press the [SRC] button.
2
Enter Audio Setup mode
Press the [VOL] knob for at least 1 second.
3
Select the Audio Setup item to adjust
Press the [VOL] knob.
Each time you press the knob, the item to be
adjusted alternates between the items shown in
the table below.
4
Setup the Audio item
Turn the [VOL] knob.
Adjustment Item
Display
Range
Front High Pass Filter*
2
"HPF-F Fc"/
"HPF"
Through/40/60/80/100/120/
150/180/220 Hz
Rear High Pass Filter*
2
"HPF-R Fc"/
"HPR"
Through/40/60/80/100/120/
150/180/220 Hz
Low Pass Filter*
1,2
"LPF-SW"/
"LPF"
50/60/80/100/120/
Through Hz
Subwoofer Phase*
1,2,3
"SW Phase"/
"PHAS"
Reverse (180°)/ Normal (0°)
Volume offset
"Vol-Offset"/
"V-OFF"
–8 — ±0
Loudness
"LOUD"
OFF/ON
Dual Zone System
"2 ZONE"/
"2ZON"
OFF/ON
• Volume offset: Sets each source’s volume as a
difference from the basic volume.
• Loudness: Compensates for low and high tones
during low volume.
• *
1
You can control this item when
(page 39) is set to "SWPRE SW". (DPX501 only)
• *
1
You can control this item when Output> (page 14) is set to "SW ON". • * 2 You can control this item when "2 ZONE"/ "2ZON" of • * 3 You can control this item when Low Pass Filter is not set to Through. • Dual Zone System Main source and sub source (Auxiliary input) output System Setting> (page 42). - Select Main source by [SRC] button.
Front channel and Rear channel separately.
- Set up the channel of sub source by
- Adjust the volume of Front channel by [VOL] knob.
- Adjust the volume of Rear channel by