Kenwood MICRO HI-FI COMPONENT SYSTEM HD-5MD - Manual (Page 77)

HD-5MD/EN
77
Knowledge
Remedy Cause Symptom
MD section (other symptoms)
÷ Insert a minidisc.
÷ Insert a recorded minidisc or a playback-
only minidisc.
÷ Return the write protection knob to its
original position or replace the disc by a
recordable disc.
÷ Record after switching the recording mode
to "ANALOG".
÷ Adjust the input level.
÷ Insert a minidisc for recording.
÷ Replace the minidisc.
÷ Set to the source to be recorded.
÷ Record for at least one second.
÷ Press the set key to cancel menu mode.
÷ Adjust the recording input level.
÷ Record again.
÷ Move away from electric devices, TVs, etc.
÷ Record in STEREO or MONO.
÷ Record at normal speed.
No sound is heard even when the MD
6 key is pressed.
Recording is not possible.
The sound is distorted.
There is much noise.
A recorded MD cannot be played on
other equipment (equipment not com-
patible with ATRAC3).
4LP recordings have much noise.
÷ No minidisc inserted.
÷ An unrecorded minidisc has been inserted.
÷ The minidisc is write-protected.
÷ Digital recording of a source with digital
copy prohibition by SCMS has been tried.
÷ The recording level is low at the time of
AUX recording.
÷ A playback-only minidisc has been inserted.
÷ There is no recordable area.
÷ The source is set to MD.
÷ The recording time is too short.
÷ The unit is in menu mode.
÷ The recording level has not been set at the
time of recording.
÷ A minidisc recorded with distorted sound is
being played back.
÷ External noise is being introduced.
÷ LP2 or LP4 recording has been performed.
÷ The disc has many scratches.
™
™
s
fi
fi
‹
w