Kenwood NEXEDGE NX-200 - Manual (Page 58)

49
■
Auto Reply Message
You can set the transceiver to automatically respond to
Individual Calls (while using FleetSync/NXDN):
1 Press the key programmed as Auto Reply Message to
enter Auto Reply Message mode.
• The icon appears on the display.
2 When you receive an Individual Call, Auto Reply will
begin after waiting for 3 seconds, the transceiver
will send an automatic response to the caller, and
“GREETING” appears on the display.
• If you are available to receive the call, press any key to
cancel the auto response.
• If there is a channel available on your transceiver for
recording, “I am not available. Leave your Message.”
will be sent to the caller. The caller can then leave a
recorded message on your transceiver which you can later
recall and listen to. When a message is stored on your
transceiver, “Msg Rcvd” appears on the display.
• If there is no channel available on your transceiver for
recording, “I am not available” will be sent to the caller and
“ MEMORY FULL” appears on the display.
■
Playback
To play back a recorded conversation, memo, or message:
1 Press the key programmed as Playback or access the
Playback function through the Menu {page 23}.
• If the last action on your transceiver was to auto record
your conversation, “STORE?” will appear on the display,
otherwise a recording channel with the time of the
recording will appear.
2 Press the / keys to select the channel you want
to play back.
• “AR” represents auto recorded conversations.
• “RM” represents auto reply messages.
• “VM” represents voice memos.