Kenwood NEXEDGE NX-200 - Manual (Page 29)

20
t
rAnSmitting
For Trunking channels, refer to “Making Group Calls (Digital)”
and “Making Individual Calls (Digital)”, below.
1 Select the desired zone and channel using the selector
knob and the Zone Up/ Zone Down or CH/GID Up/
CH/GID Down keys.
2 Press the key programmed as Monitor or Squelch Off to
check whether or not the channel is free.
• If the channel is busy, wait until it becomes free.
3 Press the PTT switch and speak into the microphone.
Release the PTT switch to receive.
• The LED indicator lights red while transmitting and green while
receiving a signal. This indicator can also be disabled by your
dealer.
• For best sound quality, hold the transceiver approximately
.5 inches (3 ~ 4 cm) from your mouth.
■
Making Group Calls (Digital)
If a key has been programmed with Group or Group +
Status, you can select a group ID from the list to make a
call to those parties. To select a group ID:
1 Press the key programmed as Group or Group +
Status.
2 Press the / keys to select a group ID/name from
the list that has been pre-entered into your transceiver.
• The target group ID/name appears on the display.
• On keypad models, you can enter a group ID by pressing
the DTMF keypad.
3 Press and hold the PTT switch to make the call.
• Speak into the transceiver as you would during a normal
transmission.