Kenwood NEXEDGE NX-200 - Manual (Page 30)

2
■
Making Individual Calls (Digital)
If a key has been programmed with Individual or
Individual + Status, you can make calls to specified
persons.
1 Press the key programmed as Individual or Individual
+ Status.
2 Press the / keys to select a unit ID from the list
that has been pre-entered into your transceiver.
• The target unit ID/name appears on the display.
• On keypad models, you can enter a unit ID by pressing the
DTMF keypad.
3 Press and hold the PTT switch to make the call.
• Speak into the transceiver as you would during a normal
transmission.
r
eceiving
1 Select the desired zone and channel using the selector
knob and the Zone Up/ Zone Down or CH/GID Up/
CH GIH/ Down keys. (If the Scan function has been
programmed, you can switch it on or off as desired.)
2 When you hear a caller’s voice, readjust the volume as
necessary.
• If signaling has been programmed on the selected channel,
you will hear a call only if the signaling tone matches the tone
set up on your transceiver.
Note: Signaling allows your transceiver to code your calls.
This will prevent you from listening to unwanted calls. It does
not make calls private, it only prevents them from being heard
by transceivers set with a different signaling code. Refer to
“SIGNALING” on page 39 for details.