Kenwood NEXEDGE NX-200 User Manual

Page 41

3 In Selcall mode, press the

keys to select the ID

of the station you want to call.

• If Manual Dialing is enabled, you can enter a status ID by

using the DTMF keypad, or by using the

keys.

When using the

keys, cycle through the digits

to select a digit, then press the

key to set the digit and

move the cursor to the right. Repeat this process until the

entire ID is entered.

4 Press the

key to enter Status mode.

5 Press the

keys to select the status ID you want

to transmit.

• If Manual Dialing is enabled, you can enter a status ID by

using the DTMF keypad, or by using the

keys.

When using the

keys, cycle through the digits to

select a digit, then press the

key to set the digit and

move the cursor to the right. Repeat this process until the

entire ID is entered.

6 Press the PTT switch or the Side 2 key to initiate the

Status call.

• “<>” is displayed when the call has been

successfully transmitted.

■

Receiving

The icon will flash and a calling ID or text message will

appear when a Status call is received. Also, if the Vibrator

function has been activated {page 40}, the transceiver will

vibrate when a Status call is received.

Press any key to return to normal operation.

■

Reviewing Messages in the Stack Memory

1 Press the key programmed as Stack, or press and hold

the key programmed as

Selcall, Status, or Selcall +

Status to enter Stack mode.

• The last received message is displayed with the message

number.

This manual is related to the following products: