Kenwood NEXEDGE NX-200 User Manual
Page 17

8
i
nStAlling
the
(o
ptionAl
) A
ntennA
Screw the antenna into the
connector on the top of the
transceiver by holding the
antenna at its base and turning
it clockwise until secure.
Do not use glue which is designed
to prevent screw loosening when
installing the belt clip, as it may
cause damage to the transceiver.
Acrylic ester, which is contained
in these glues, may crack the
transceiver’s back panel.
i
nStAlling
the
B
elt
c
lip
If necessary, attach the belt clip
using the two supplied 3 x 8 mm
binding screws.
Note: If the belt clip is not
installed, its mounting location
may get hot during continuous
transmission or when left sitting in
a hot environment.
1
2ABC
4
GH
I
3 DEF
MIC
Optional
antenna
Binding screws
Belt clip
This manual is related to the following products: