KORG ES-1 - Manual (Page 8)

8
2. Front and rear panel ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
1
2
7
3
5 6
4
10 8 9
2. Front and rear panel
The controls and other parts of the ES-1 each
fall into one of six groups:
Common section
1. MASTER VOLUME
This knob adjusts the volume that is output from
the line out jacks and the headphone jacks.
2. AUDIO IN THRU
This key sends the external output directly to the
line out jacks and headphone jack.
When this key is on, the Pan, Level, Filter, Effect,
and Roll of the Audio In part will have no effect.
3. Display
This shows the value of the currently selected pa-
rameter, and various messages.
4. Dial
Use this to modify the value shown in the display.
5. Peak LED
This indicates the peak level for the input signal from the audio in jacks. Adjust the
output level of your external device so that the LED lights only at the maximum level.
6. Beat LED
This will blink at quarter-note intervals to indicate the tempo.
7. [
▲][▼] (cursor keys)
In each mode, use these keys to select parameters from the matrix shown in the display.
8. Matrix
The parameters that will appear in the display are listed here for each mode. Use the
cursor keys to make the desired parameter select LED light.
9. Mode keys
Use these keys to move to the desired mode: Pattern, Song, Sample, or Global. Dur-
ing playback you can move to Global mode, but not to Sample mode.
10. WRITE (WRITE key)
This key is used to save the contents that you modified in Pattern, Song, Sample, and
Global mode, to save Pattern Set data, and to save sample data that you sampled.
Sequence
control section
Common section
Step key section
Effects
section
Part select
section
Connector section
Part edit
section