Kodak i100 Series - Manual (Page 44)

A-61517 October 2004
3-21
Overscan values Overscan allows you to add a specified value (inches/mm) before and
after the edge of the image. Overscan values can be applied to the top
and bottom of an image and/or the left and right of an image. Overscan
is used in applications where automatic feeding of excessively skewed
documents is likely. Overscan reduces the possibility of corner clipping
on skewed images. Overscan can only be used with Fixed or Transport
cropping.
To set Overscan values, select where you want to apply Overscan
values: Top/Bottom, Left/Right; All Sides then select the amount of
inches/mm you want applied. Select a value within the range of 0 to .375
inches. (none) is the default. Combined Overscan and Length values
cannot exceed 17.75 inches.
Additional paper selections In addition to cropping and overscan values that can be applied using
the Paper tab, the following options are available:
Preset Front/Rear Size  the default paper size is set when a scanner
is first selected. You can choose a different paper size using the
drop-down list box.
Units
 defines the primary measurement system. Inches,
Centimeters, Picas, Points, 20 th of Points, and Pixels are available.