Kodak i100 Series - Manual (Page 28)

A-61517 October 2004
3-5
Buttons on the Kodak
Scanner Properties
dialog box Following are descriptions of the buttons located at the bottom of the
dialog box.
Defaults  when you select Defaults, the message Reset all values
to factory defaults? will be displayed. Clicking Yes will reset all values
on all tabs to the factory default settings.
Copy  will copy the settings of the front camera to the rear camera for
the selected camera (bi-tonal, color or grayscale). For example, if you
have Front Bi-tonal camera highlighted, these values will be copied to
the Rear Bi-tonal camera. If you have the Front Color camera
highlighted, these values will be copied to the Rear Color camera.
OK  saves the values set on all tabs.
Cancel  closes the dialog box without saving any changes.