Kenwood TM-D700 E User Manual
Page 57
51
9
■
Locking Out a Memory Channel
Select memory channels that you prefer not to
monitor while scanning.
1 Recall the desired memory channel.
2 Press [MNU] to enter Menu mode.
3 Press [
c
c
c
c
c
]/ [
d
d
d
d
d
] to select “RADIO (1–)”, then press
[OK].
4 Press [
c
c
c
c
c
]/ [
d
d
d
d
d
] to select “MEMORY (1–4–)”, then
press [OK].
5 Press [
c
c
c
c
c
]/ [
d
d
d
d
d
] to select “LOCKOUT (1–4–3)”,
then press [OK].
6 Press [
c
c
c
c
c
]/ [
d
d
d
d
d
] to switch Lockout ON (or OFF).
7 Press [OK] to complete the setting.
8 Press [MNU] to exit Menu mode.
• A star appears to indicate the channel has been
locked out.
Note: The L0 to L9 and U0 to U9 memory channels cannot be
locked out.
GROUP SCAN
For the purpose of Group Scan, the 200 memory
channels are divided into 10 groups, with each group
containing 20 channels. Group Scan monitors only the
20 channels which belong to the specified group. The
channels are grouped as below:
1 Recall one of the memory channels in the desired
group.
2 Press [MHz] (Tuning control) (1 s).
•
Scan starts with the channel last recalled.
•
The 1 MHz decimal blinks while scanning is in progress.
•
To reverse the scan direction, turn the Tuning control
clockwise (upward scan) or counterclockwise
(downward scan). You can also press Mic [UP]/ [DWN].
3 To quit Group Scan, press [MHz] again.
Note:
◆
At least 2 or more memory channels in the specified group must
contain data and must not be locked out.
◆
You can also start Group Scan when in Channel Display mode.
While Scan is being interrupted, the channel number blinks.
0
2
~
1
.
s
o
N
0
2
1
~
1
0
1
.
s
o
N
0
4
~
1
2
.
s
o
N
0
4
1
~
1
2
1
.
s
o
N
0
6
~
1
4
.
s
o
N
0
6
1
~
1
4
1
.
s
o
N
0
8
~
1
6
.
s
o
N
0
8
1
~
1
6
1
.
s
o
N
0
0
1
~
1
8
.
s
o
N
0
0
2
~
1
8
1
.
s
o
N