Kenwood TM-D700 E - Manual (Page 18)

12
3
MAIN UNIT- FRONT
q q q q q COM connector
Accepts a DB-9 female connector for connecting to a
computer. See the separate manual, “SPECIALIZED
COMMUNICATIONS” {page 2}.
w w w w w GPS jack
Accepts a 2.5 mm (1/10") 3-conductor plug for
connecting to a GPS receiver. See the separate manual,
“SPECIALIZED COMMUNICATIONS” {page 10}.
e e e e e DATA connector
Accepts a 6-pin mini DIN plug for connecting to an
external TNC or an optional VC-H1. See the separate
manual, “SPECIALIZED COMMUNICATIONS” {pages 2
and 35}.
r r r r r PANEL connector
Insert one end of the supplied modular plug cable for
connecting the front panel {page 4}.
t t t t t MIC connector
Insert the modular plug on the microphone cable until
the locking tab clicks {page 8}.
y y y y y RESET button
Press for 1 second or longer to perform Full Reset
{page 41}. No confirmation message appears. Use
this switch when the microcomputer and/or the
memory chip malfunction because of ambient factors.
Note: With the transceiver power ON, do not connect cables to or
remove from the front panel of the main unit.
MAIN UNIT- REAR
q q q q q Antenna connector
Connect an external antenna {page 7}. When making
test transmissions, connect a dummy load in place of
the antenna. The antenna system or load should
have an impedance of 50
Ω
. The TM-D700E accepts
a male N-type connector and other versions accept a
male PL-259 connector. This transceiver has only
one antenna connector because of a built-in duplexer.
w w w w w Power Input 13.8 V DC cable
Connect a 13.8 V DC power source. Use the
supplied DC power cable {pages 5 and 6}.
e e e e e Speaker jacks
If you wish, connect an optional external speaker for
clearer audio. These jacks accept a 3.5 mm (1/8")
mono (2-conductor) plug. See page 8.