Kenwood TM-D700 E - Manual (Page 51)

45
8
AUTO PM CHANNEL STORE
After you recalled a PM channel, this function
automatically overwrites the current PM channel with the
present operating environment when:
• You recall another PM channel.
• You press [OFF].
• You switch OFF the transceiver.
The factory default of this function is ON.
1 Press [MNU] to enter Menu mode.
2 Press [ c c c c c ]/ [ d d d d d ] to select “RADIO (1–)”, then press
[OK].
3 Press [ c c c c c ]/ [ d d d d d ] to select “MEMORY (1–4–)”, then
press [OK].
4 Press [ c c c c c ]/ [ d d d d d ] to select “AUTO PM STORE (1–4–1)”,
then press [OK].
5 Press [ c c c c c ]/ [ d d d d d ] to switch the function ON (default) or
OFF.
6 Press [OK] to complete the setting.
7 Press [MNU] to exit Menu mode.
PM CHANNEL RESET
If you want to reprogram the PM channels from the
beginning, reset all the PM channels to the factory
defaults.
1 Press [PM]+ POWER ON.
• A confirmation message appears.
• Press [ESC] to quit resetting.
2 Press [OK].
You can also use Menu 1–9–7 (RESET) to reset the PM
channels. See page 41.