Kenwood KDC-BT742U - Manual (Page 29)

English |
29
Downloading the Phone Book
Download the phone book data from the cell-
phone to this unit so that you can use the Phone
Book of this unit.
To download automatically
If the cell-phone supports a phone book
synchronization function, the phone book is
downloaded automatically after Bluetooth
connection.
⁄
• Setting on the cell-phone may be required.
• If no phone book data is found in the unit even after
the compete display, your cell-phone may not support
automatic download of phone book data. In this case, try
downloading manually.
To download from the cell-phone manually
1 By operating the cell-phone, end the hands-free
connection.
2 By operating the cell-phone, send the phone
book data to this unit
By operating the cell-phone, download the phone
book data to this unit.
• During downloading:
“DOWNLOADING” is displayed.
• After completion of downloading:
“COMPLETE” is displayed.
3 By operating the cell-phone, start the hands-
free connection.
2 Input the PIN code
Operation type Operation
Select the numbers. Turn the [AUD] knob or push it towards
up or down.
Move to the next digit. Push the [AUD] knob towards right.
Delete the last digit. Push the [AUD] knob towards left.
3 Register a PIN code
Press the [AUD] knob for at least 1 second.
If “COMPLETE” is displayed, registration is
completed.
4 Exit the PIN code edit mode
Press the [SEARCH] button.
⁄
• By default, “0000” is specified.
• A PIN code can be specified with up to eight digits.
To clear the downloading completion message
Press any button.
⁄
• Up to 1000 phone numbers can be registered for each
registered cell-phone.
• Up to 32 digits can be registered for each phone number
along with up to 50* characters representing a name.
(* 50: Number of alphabetic alphabetical characters.
Fewer characters can be input depending on the type
of characters.)
• To cancel downloading of the phone book data, operate
the cell-phone.
Selecting the Bluetooth device You
Wish to Connect
When two or more Bluetooth devices have already
been registered, you need to select the Bluetooth
device you wish to use.
1 Enter Bluetooth device selection mode
Select “MENU” > “PHONE SEL”.
Press the [AUD] knob for at least 1 second.
For how to select Function Control item, refer to
(page 6).
‘(name)’ is displayed.
2 Select the Bluetooth device
Turn the [AUD] knob or push it towards up or
down.
3 Set up the Bluetooth device
Push the [AUD] knob towards right or left.
‘
✱(name)’ or ‘-(name)’ is displayed.
“ ✱”: The selected Bluetooth device is busy.
“-”: The selected Bluetooth device is on standby.
“ “ (blank): The Bluetooth device is deselected.
4 Exit the Bluetooth device selection mode
Press the [SEARCH] button.
⁄
• If a cell-phone is already selected, deselect it, and then
select a different one.
B64-4314-00_00.indb 29 08.11.1 2:43:48 PM